TentCheck

MSR Hubba Hubba LT 2

Floor 88 × 52 in, 40 in peak, vestibules 8 sq ft + 8 sq ft. Drawn to scale from the maker's listing; the grid is 6 in.

Which pads fit

2 regular padsFits

An inch or more to every wall. Sit-up room +3.3 in.

2 wide padsFits

An inch or more to every wall. Sit-up room +2.7 in.

2 mummy padsFits

An inch or more to every wall. Sit-up room +3.3 in.

A regular pad and a wide padFits

An inch or more to every wall. Sit-up room +2.7 in.

Pads side by side at their listed sizes, with the average man (5 ft 9 in) lying on each. "Tight" is under an inch to a wall or the sloping roof: the fabric gives, but a wet wall wets what touches it. Open it in TentCheck to try your own pads, cots and gear, or read how fits are checked.

Headroom

Roof overheadFloorShare
Anywhere31.8 sq ft100%
12 in or more31.1 sq ft98%
24 in or more26.2 sq ft82%
36 in or more12.5 sq ft39%

From the modeled roof, not measured. About 36 in is where an average adult sits up straight on a pad: a 35 in sitting height, plus the pad.

The numbers

Floor (listed)88 × 52 in, 31.8 sq ft
Peak40 in (3 ft 4 in)
Vestibules8 sq ft + 8 sq ft
Sleeps (maker)2
Packed weight54 oz (3 lb 6 oz)
Packed volume7.8 L
Regular pads that fit2 with an inch to every wall
Sit-up room on a pad, at the peak+4 in for 35 in sitting height
Pitched footprint88 × 100.9 in (7 ft 4 in × 8 ft 5 in), floor and vestibules
Groundsheet to cutAbout 86 × 50 in

On the campsite

Floor and vestibules together cover 88 × 100.9 in. On a square tent pad, as campgrounds list them: 8 × 8 ft: doesn't fit; 10 × 10 ft: fits; 12 × 12 ft: fits. Guylines and stakes need more room around that.

For a groundsheet, cut it a little smaller than the floor, about 2 in, so rain running off the fly doesn't collect on it and run under the tent: about 86 × 50 in.

Notes

Floor 88 × 52 in with no taper, 40 in peak, two 8 ft² side vestibules. MSR lists the 32 ft² floor and 16 ft² of vestibules; the floor's dimensions and the 8 + 8 split are REI's listing. It replaced the Hubba Hubba 2.

Sources

Roof shapes are modeled from the floor, the peak and how the poles hold the walls, not measured. Treat a result within an inch or two as too close to call.